Bosch ADS 325 User Manual page 49

Summary Report
ss03209
Connected to 2007 Jeep Wrangler Unlimited X 3.8L
Automated System Test
Summary
Summary
VIN:1FTPW14V28FC54321
DTCs
CALIBRATION ID(S):BOSCHA1037366956, 4EF7033C
Add Image(s) to Report
Data Stream Snapshot
DTCs Found
Mode 1
108
Freeze Frame
Oxygen Sensor Tests
Mode 5
AST summary reports items found on the vehicle, such
as:
• Controllers found on vehicle.
• DTCs.
• Data Stream Snap Shot.
• Mode 1 (Readiness Monitor).
• Freeze frame.
• Mode 5 (O2 sensor).
• Mode 6 (Non-continuous monitor tests).
NOTE: Available selections will vary from vehicle to vehicle.
DTCs
ss03210
Connected to 2007 Jeep Wrangler Unlimited X 3.8L
Automated System Test
Diagnostic Trouble Codes
Summary
DTCs
TRANSMISSION
P0078 - Active - Exhaust Valve Control
Data Stream Snapshot
Circuit (Bank 1)
P0560 - Active - Battery System
Mode 1
Voltage
P0613 - Active - Internal Transmission
Freeze Frame
Processor
P0078 - Reading - Exhaust Valve
Mode 5
DTCs recorded are displayed. When selecting DTCs,
diagnostic information is also available (same informa-
tion as the Read DTCs screen).
Bosch Automotive Service Solutions Inc
Change Vehicle Home
Clear DTCs Refresh Share Save
CONTROLLER:ENGINE
Data Items Freeze Frame Data (Mode
2)
20 19
Non Continuously Monitored Tests (Mode 6)
Change Vehicle Home
Clear DTCs Refresh Share Save
9 DTC(s) found
Details
Details
Details
Data Stream Snapshot
ss03211
12:44
Connected to 2007 Jeep Wrangler Unlimited X 3.8L
Automated System Test
Data Stream Snapshot
Summary
Global OBDII
DTCs
Description
Data Stream Snapshot
Boost Pressure Sensor A
Mode 1
Boost Pressure Sensor B
Freeze Frame
Commanded Boost Pressure A
Mode 5
Data stream Snapshot, is a current view of the onboard
vehicle sensors.
Mode 1 (Readiness Monitor)
ss03212
Connected to 2007 Jeep Wrangler Unlimited X 3.8L
Automated System Test
Readiness (Mode 1)
Summary
Monitor Description
DTCs
A/C System Refrigerant Monitor
Data Stream Snapshot
EGR System Monitor
12:45
Mode 1
Catalyst Monitor
Heated Catalyst Monitor
Freeze Frame
Misfire Monitor
Mode 5
Readiness Monitor Tests displays the results from the
continuous monitors available on the selected vehicle.
There are three states: ready, not ready, and not sup-
ported. If the monitor is not ready, a drive cycle must be
completed prior to running this test. For more informa-
tion regarding drive cycles, refer to diagnostic functions
Mode 1 readiness.
ADS 325 | User Manual | 47 | en
Change Vehicle Home
Clear DTCs Refresh Share Save
Value
212.8 psi
194.2 psi
255.4 psi
Change Vehicle Home
Clear DTCs Refresh Share Save
Status
Ready
Ready
Ready
Ready
Ready
582819 | REV. A | 07.2018
12:45
12:45