Keep The Softener - Kenmore 625.34854 Owner's Manual

SECTION 3
CARE OF YOUR SOFTENER
3C. KEEP THE SOFTENER FROM FREEZING
11[_ ill
If the softener is installed where it could freeze
(summer cabin, lake home, etc.), you must drain
all water from it to stop possible freeze damage.
To drain the softener -
1. Close the shut-off valve on the house main
water pipe, near the water meter or pressure
tank.
2. Open a faucet in the soft water pipes to vent
pressure in the softener.
e
Refer to FIG. 12 on page 19. Move the stem in
a single bypass valve to bypass. Close the
inlet and outlet valve in a 3-valve bypass
system, and open the bypass valve. If you
want water in the house pipes again, reopen
the shut-off valve on the main water pipe.
4. Unplug the transformer at the wall outlet.
Remove the salt hole cover and the main
cover. Take off both drain hoses.
e
Carefully remove the large holding clips at
the softener inlet and outlet (see Key No. 61,
on page 30). Separate the softener from the
adaptors or bypass valve.
Go
Remove the brinewell cover and disconnect
the brine valve tubing at the nozzle and
venturi assembly (see page 30). Lift the brine
valve out of the brinewell. Tip the brine valve
upside down to drain out water.
o
e
DRAIN WATER FROM THE
SOFTENER
Drain Wood Block
Looking at FIG. 11, lay a piece of 2 inch thick
board near the floor drain. Move the softener
close to the drain. SLOWLY and CAREFUL-
LY tip it over until the rim rests on the wood
block with the inlet and outlet over the drain.
Do not allow the softener _ weight to rest on
the inlet and outlet fittings or they will
break.
Tip the bottom of the softener up a few inches
and hold until all water has drained. Leave
the softener laying like this until you are
ready to use it. Plug the inlet and outlet with
rags to keep dirt, bugs, etc. out.
17