Monogramming; Embroidery - Kenmore 385.17724 Owner's Manual

=
Monogramming
Set the Machino
Stitch wLdth
control 5
i 2 3 4
@
Top thread tension
control 2 to G
F' Satin stitch
foot
Stitch length
control 0.5 to ]
2
Stretch Stitch
34
Here's How
1. Set the same as satin stitch.
2. Back the fabric with paper or
interfacing.
3. Draw the letters on the fabric
with tailor's chalk.
4. Satin stitch, adjusting the stitch
width as necessary to form each
pattern,
5. If using paper, carefully remove it
when you have finished sewing.
Embroidery
Set the Machine
Stitch w=dth
control 1 to 5
_ 2 3 4
Top thread tension Stitch length control
control 2 to 6 Any number (not
necessary to adiust)
No pre_er
foot Stretch Stitch
Darn m9 plate
Here's How
1. Put the darning plate on the needle
plate (see page 29),
2, Remove foot holder (see page 10),
3. Adiust the stitch width as desired
(see page 21 ),
4. Draw the design on to the fabric
with tailor's chalk.
5. Stretch the. fabric between embrol-
dery hoops and place under the
needle.
6, Lower the presser foot lever to
engage the top thread tension.
7, Holding the top thread in your left
hand, rotate the hand wheel toward
you one complete turn.
Pull the top thread to draw the
bobbin thread through to the surface
of the fabric.
8. Using a medium speed, stitch along
the marked outline, guiding the
fabric carefully by hand.