Installing Pulley Cover; Installing Sanding Disc Plate - Craftsman 113.226424 Owner's Manual

INSTALLING PULLEY COVER
1. Locate the pulley cover and one screw
114-20xl -3/4"
2. Place pulley cover into position shown and
fasten with one screw. Do not overtighten.
PULLEY COVER
INSTALLING SANDING DISC PLATE
1. Locate sanding disc plate, sanding disc, one
setscrew 1/4-20xl/4 inch, and a 1f8 inch hex
wrench.
2. Just start screw into threaded hole in sand-
ing plate.
SET SCREW
WRENCH
SANDtNG DiSC PLATE
I
i I I IIIIII II /I
.
,
Align flat on shaft with setscrew in sanding
plate. Slide sanding plate onto shaft until
plate surface and shaft are nearly flush. Do
not allow shaft to extend out past surface of
sanding plate or damage may occur to your
sanding disc during operation.
SANDING
DR_VE PLATE
SHAFT_
GUARD NO"f
SHOWN FOR
CLARITY
To tighten setscrew, reach through hole in
top of pulley cover with hex wrench. Tighten
setscrew very firmly.
_FLAT _...,._
N SHAFT)
SAND;NG \ \
HEX
WRENCH
SET
SCREW
SECTION OF
PULLEY COVER
REMOVED FOR
P_CTURE CLARITY