Servicing Position - Yamaha TSX-10 Service Manual

TSX-10/15/20

SERVICING POSITION

When performing inspections, use the positions as shown in the figure.
Be sure to pay attention to the following items when performing inspections.
1. Static electricity
2. Polarity of connectors
3. Laser light from the pickup
Be sure to load a CD before turning on the power and take it out after turning off the power. Never turn on the power
without a CD loaded .
Procedure:
1. Remove the Motor Unit by performing Steps 1 and 3, a and b of the DISASSEMBLY PROCEDURES.
2. Where the Motor Unit has been removed, position the CD drive unit fixing jig as shown in the photo and fix it with 3
screws.
3. Reconnect the connectors that have been disconnected in the original state. However, use an extension cable for
connection between W3 of the MAIN (1) P.C.B. and CB206 of the DIGITAL (2) P.C.B.
• Extention Cable
Part No. Pin
MF407300 7P
9
Connection
MAIN (1) P.C.B. (W3) ↔ DIGITAL (2) P.C.B. (CB206)