Sanyo POA-MD13NET2 Owner's Manual page 104

Chapter 2 Installation
Network configuration
Confirmation of the network menu
When installing this product to the projector, the network on-screen menu items for
this product are activated automatically. If not activated, the product may not have
been installed correctly. Please check item "Mounting" (
Configure the network
When you connect the projector to the network, the network number of projector
must be the same as the network you intend to connect. You should configure pro-
jector's network first.
This example explains how to set the following configuration.
IP Address
Subnet Mask
Default Gateway
DNS
The default network configuration is set as follows.
IP Address
Subnet Mask
Default Gateway
DNS
1
Selection of network menu [Network]
Turn on the projector and display the menu on the screen. Select the Network icon
from the Setting sub menu using the point buttons (d e 7 8) and then press the
SELECT button on the remote control or on the projector. Confirm that its mode
is set "On". If not, change mode to "On" using the point buttons 7 8.
16
: 192.168.1.201
: 255.255.255.0
: 192.168.1.1
: 0.0.0.0
: 192.168.0.2
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
* The above on-screen display may differ from
the actual display depending on the functions
of the projector you use.
p.14).