LAN Power LP-2590 Installation Manual

This guide provides information and procedures for the product installation and operation of the Single Port ULTRA HIGH
POWER Power over Ethernet (PoE) Midspan Injector (LP-2590). This document is intended for the technical personnel respon-
sible for installing and operation of Power over Ethernet products in a Local Area Network (LAN) environment. To use this docu-
ment effectively, you should have working knowledge of Local Area Networking (LAN) concepts and hardware installation. In
addition, you should be familiar woth the following: connection of patch Cables with RJ45 connectors and the LAN addressing
map of your particular Network, mounting of network hardware and cables and local practices for power cord connections.
Read and keep these instructions. Follow all instructions and heed all warnings. Do not use this equipment near water and
clean only with a dry cloth. Do not block any equipment ventilation openings. Install in accordance with these instructions. Do
not install near any heat sources such as radiators, heat registers, stoves, or any other
produce heat. Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with
one wider that the other. The Mains Clip has two blades and will fit into a standard Mains Outlet—DO NOT force the clips into
any outlet. Unplug this equipment during lightning storms or when unused for long periods of time. Refer all servicing to
qualified service personnel. Servicing is
damaged, liquid has been spilled, or object has fallen into the equipment, the equipment has been exposed to rain or moisture,
does not operate normally, or has been dropped. The AC mains outlet, or appliance coupler shall be readily available to the
operator as a means of power disconnection.
WARNING - Only connect equipment to mains power outlet having protective earthing or grounding connection. To reduce the
risk of fire or electric shock, do not expose this equipment to rain or moisture.
CAUTION - These servicing instructions are for use by qualified service personnel only. To reduce the risk of
do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.
If You Need Help or additional support relating to the contents of this Guide, please contact LAN-Power at
+1 (510) 275-4572
Before contacting LAN-Power for technical support, please have the following information ready: Your product
model number and unit serial number. A description of the failure or symptoms of problem. A description of any action(s) already
taken to resolve the problem (e.g. changing ports, rebooting the unit, etc.). The type of End Device being powered including
Manufacturer name and part number. Powering requirements of end device. A description of your Network environment (layout,
Ethernet switch description, cable type(s), etc.). The unit history (i.e. has the unit been returned before, is this a recurring prob-
lem, etc.)
Please note that only qualified personnel should install this
unit and read instructions before attempting to install unit
Verifying Contents of Package - Unpack the PoE Injector and verify that you have all the
following items: LP-2590 Single Port ULTRA HIGH POWER Power over Ethernet Injector base unit
and 3-Pin AC Mains Cable and this Installation Guide.
Technical Considerations - Before you mount the PoE Injector to a fixed location, consider all the following: determine
optimal placement, check patch cord routing and AC outlet location. Collect and document Network information as required.
ENSURE the cable length from the Ethernet Network Switch to the powered IP enabled end device does not exceed 328
feet / 100 meters total length including all cables and connections. NOTE: The PoE Injector IS NOT a repeater and DOES
NOT amplify the Ethernet data signal. The Injector must be used in conjunction with an Ethernet Switch.
Single Port ULTRA HIGH POWER PoE Midspan Injector
Up to
IMPORTANT SAFEY INSTRUCTIONS
required the equipment has been damaged in any way, such as power cord or plug
or more information can be found at
LP-2590
90 Watt
PoE Power Output
Installation Guide
Purpose of this Guide
www.lan-power.com
apparatus (including amplifiers) that
electric shock,