Sony TC-KA6ES Operating Instructions Manual page 8

Getting Started
To connect your tape deck to another tape deck
Connect both tape decks as shown below.
Tape deck
LINE
IN OUT
L
R
Setting the voltage selector (only on models
supplied with a voltage selector)
Check that the voltage selector on the rear panel of the
tape deck is set to the local power line voltage. If not,
set the selector to the correct position using a
screwdriver before connecting the AC power cord to
an AC outlet.
Connecting the AC power cord
Connect the AC power cord to an AC outlet.
The dape deck's Memory Backup function (page 17)
keeps the various settings in memory even after you
trun off the power as long as AC power cords is
plugged in.
Where do I go next?
Now you're ready to use your tape deck.
For basic operations, go to pages 4 to 6; for advanced
operations, go to the sections immediately after this one.
EN
8
Another tape deck
LINE
IN OUT
L ç L L
R R R
Ç
V OLT A G E
220V
240V
120V