Advertisement
Quick Links
Advertisement
Related Manuals for Samsung S Band
Summary of Contents for Samsung S Band
- Page 1 Type E. AXXXXX www.samsung.com 05/2013. Rev. 1.0...
- Page 2 S Band User manual...
- Page 3 Contents English ..........................1...
-
Page 4: Safety Precautions
Do not disassemble, modify, or repair the device Any changes or modifications to the device can void your manufacturer’s warranty. For service, take the device to a Samsung Service Centre. When using the device, mind the following: • Humidity and liquids may damage parts or electronic circuits. - Page 5 Overview Indicator light Setting button Micro USB cover Check the product box for the following items: S Band, Micro USB cable, and user manual. The supplied items may vary depending on the region.
- Page 6 Charging the S Band The device has a rechargeable internal battery which is non-removable. Make sure they are fully charged before using it for the first time. • Use only Samsung-approved chargers. • The travel adapter is sold separately.
- Page 7 Connect the travel adapter to the charging socket on the device. Plug the travel adapter into the wall outlet. During charging, the indicator light will turn red. If the red indicator light flashes, unplug the travel adapter and plug it in again. When fully charged, the indicator light turns green.
- Page 8 Wearing the S Band Stretch out both sides of the device, and wear it on your wrist. Do not pull or stretch out the device too hard to avoid damage of the device.
- Page 9 Connecting Press and hold the setting button to enter Pairing mode until the indicator light flashes red, green, and blue for 30 seconds. On the smartphone, launch the S Health application. Tap Health board → Walking mate → → S Band.
- Page 10 Tap Scan to search for the device. To pair with the smartphone, select the device from the list of available devices. • Once pairing is complete, the blue or white indicator light stays for 3 seconds, and then turns off. • When the device is connected, the green indicator light flashes for 5 seconds, and then turns off.
- Page 11 On the smartphone, launch the S Health application. Tap Health board → Walking mate → → S Band. Tap Disconnect to disconnect the device from the smartphone. To check the disconnection, press the button. The blue or white indicator light stays for 30 seconds.
-
Page 12: Using Modes
Using modes The device can be used in two modes, walking mate and sleep monitor modes. In walking mate mode, steps can be counted, and sleep efficiency can be measured in sleep monitor mode. Changing and checking modes To switch between walking mate and sleep monitor modes, press and hold the button for 3 seconds. - Page 13 Forgetting and Resetting the S Band The device needs to be unpaired and reset data to pair with other smartphones. Forgetting the device On the smartphone, launch the S Health application. Tap Health board → Walking mate → → S Band → Unpair.
-
Page 14: Fcc Warning
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Statement (2.1091) This Equipment complies with FCC RF Radiation Exposure limits set forth for an uncontrolled environment. - Page 15 IC Warning "This device complies with Industry Canada licence-exempt RSS standard(s)." Operation is subject to the following conditions: (1) this device may not cause interference, and (2) this device mustaccept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas provoquer de brouillage, et (2)l'appareil doit...
- Page 16 IC Warning RF du FCC d'exposition aux radiations: Cet équipement est conforme à l'exposition de la FCC rayonnements RF limites établies pour un environnement non contrôlé. Cet appareil et son antenne ne doivent pas être co-localisés ou fonctionnant en conjonction avec une autre antenne ou transmetteur.