This label is located on the bottom of the chassis.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
: LEAD FREE MARK
Unleaded solder has the following characteristics.
•
Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
•
Strong viscosity
Unleaded solder is more viscous (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
•
Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
Downloaded from
www.Manualslib.com
CDX-GT50UMS/GT450U/GT457UE/GT500U/GT500US/GT505U
the lead free mark due to their particular size)
the heated tip is applied for too long, so be careful!
manuals search engine
TABLE OF CONTENTS
1.
......................................................
2.
Connections ....................................................................
3.
3-3. Main Board ..................................................................... 10
3-4. Servo Board .................................................................... 10
4.
5.
5-1. Main Section ................................................................... 28
6.
4
5
9
9
............................... 31
3