Printing A Network Configuration Page; Static Addressing - Samsung CLP-600 Series User Manual

Printing a Network Configuration Page

The Network Configuration page shows how the network
interface card on your printer is configured. The default settings
which are suitable for most applications are enabled.
1
In ready mode, press the Menu button (
"Network" on the bottom line of the display.
2
Press the Enter button (
3
Press the scroll button (
displays on the bottom line.
4
Press the Enter button (
The Network Configuration page prints out.
Setting Network Protocols
When you first install the printer, all supported network
protocols are enabled. If a network protocol is enabled, the
printer may actively transmit on the network even when the
protocol is not in use. This may increase network traffic slightly.
To eliminate unnecessary traffic, you can disable unused
protocols.
1
In ready mode, press the Menu button (
"Network" on the bottom line of the display. Press the
Enter button ( ) to access the menu.
2
Press the Enter button (
displays on the bottom line.
3
Press the scroll button (
and press the Enter button (
Level button ( ).
4
Press the scroll button (
desired protocol on the bottom line.
You can choose between "Config TCP" and "Netware".
5
Press the Enter button (
6
Press the scroll button (
If you selected "Config TCP", change the setting to "No"
(disable) or "Yes" (enable).
If you selected "Netware", change the setting to "Off"
(disable) or "On" (enable).
7
Press the Enter button (
8
Press the On Line/Continue button (
ready mode.
) until you see
) to access the menu.
or ) until "Print Net CFG"
).
) until you see
) when "Config Network"
or ) until "Yes" displays,
). Then press the Upper
or ) until you see the
).
or ) to change the setting.
) to save the selection.
) to return to
Using Your Printer on a Network (CLP-600N only)
Configuring TCP/IP
Your printer can be set up on a variety of TCP/IP networks.
There are several ways in which your printer can be assigned a
TCP/IP address, depending on your network.
• Static Addressing: TCP/IP address is assigned manually by
the system administrator.
• Dynamic Addressing BOOTP/DHCP (default): TCP/IP address
is assigned automatically by the server.

Static Addressing

To enter the TCP/IP address from your printer's control panel,
take the following steps:
1
In ready mode, press the Menu button (
"Network" on the bottom line of the display. Press the
Enter button (
2
Press the Enter button (
displays on the bottom line.
3
Press the scroll button (
and press the Enter button (
4
Press the Upper Level button (
button (
5
Press the Enter button (
6
Press the scroll button (
and press the Enter button (
7
Press the Upper Level button (
button (
8
Press the Enter button (
displays.
9
Press the scroll button (
and press the Enter button (
10
Press the Upper Level button (
button (
11
Press the Enter button (
An IP address consists of 4 bytes.
12
Press the scroll button (
between 0 and 255 and press the Enter button (
8.2
) to access the menu.
) when "Config Network"
or ) until "Yes" displays,
).
), then use the scroll
).
) when "Config TCP" displays.
or ) until "Yes" displays,
).
), then use the scroll
).
) when "IP Get Method"
or ) until "Static" displays,
).
), then use the scroll
).
) when "IP Address" displays.
Enter a number between 0
and 255 for each byte.
or ) to enter a number
) until you see
).