Advertisement
English
Precaution
To avoid contamination, do not touch the board connector.
Introduction
The UB-U01III/U02III/U03II, designed for EPSON
interface board.
❏
When you install the UB-U01III/U02III, you cannot use a display module
connector (DM connector) on the printer. Use the DM connector on the
UB-U01III/U02III.
❏
The UB-U01III uses a bus-powered hub. Note that it cannot be directly
connected to other bus-powered hubs (including the UB-U01III) or bus-
powered functions that consume current over 100 mA. (The UB-U02III
and UB-U03II can be directly connected to the hub on the UB-U01III.)
Operation Environments When Using USB Port
❏
Operation Environments
Hardware: USB compliant PC
OS:
For detailed information on other operating systems, please ask your
dealer.
Software:
Please ask your dealer how to get the device driver for the UB-U01III/
U02III/U03II and how to install it.
Note:
Even if the above operation environments are satisfied, your system may not work
properly, depending on the devices connected to your system.
Unpacking
Make sure you have these items. If any item is missing or damaged, please
contact your dealer for assistance. If necessary, you can get a locking wire
strain relief separately through your dealer by using the part numbers listed
below in brackets.
❏
UB-U01III/U02III/U03II
❏
This manual
❏
Ferrite core [2031678]
❏
Locking wire strain relief
•
For UB-U01III/U02III [1061268]
•
For UB-U03II [1091047]
Windows 98 or later (Second Edition is recommended)
You need a device driver when you use the product.
®
2
TM printers, is a USB
Advertisement
