Troubleshooting - Samsung HT-BD2S User Manual

troubleshooting

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed
below or if the instruction below does not help, turn off the unit, disconnect the power cord, and contact the nearest
authorized dealer or Samsung Electronics Service Center.
SYMPTOM
I cannot eject the disc.
Playback does not start.
Playback does not start
immediately when the
Play/Pause button is pressed.
Sound is not produced.
Sound can be heard only from a few
speakers and not all 8.
Dolby Digital 5.1 CH Surround Sound is
not produced.
The remote control does not work.
• Disc is rotating but no
picture is produced.
• Picture quality is poor and
picture is shaking.
Audio language and subtitles do not work.
Menu screen does not appear even
when the menu function is selected.
Aspect ratio cannot be changed.
Check/Remedy
• Is the power cord plugged securely into the outlet?
• Turn off the power and then turn it back on.
• Check the region number of the BD/DVD.
BD/DVD discs purchased from abroad may not be playable.
• CD-ROMs and DVD-ROMs cannot be played on this Blu-ray Home Theater.
• Make sure that the rating level is correct.
• Are you using a deformed disc or a disc with scratches on the surface?
• Wipe the disc clean.
• No sound is heard during fast playback, slow playback, and step motion playback.
• Are the speakers connected properly? Is the speaker setup correctly customized?
• Is the disc severely damaged?
• When listening to a CD or radio, sound is output from the front speakers
(L/R) only. To enjoy sound over 7 or 8 speakers select the D.PL IIX, Neo:6
or SFE MODE modes.
• If you set SBL and SBR to NONE in the speaker mode in the audio setup of
the setup screen, no sound is heard from the SBL and SBR speakers.
Set SBL and SBR to Small.
• Is there "Dolby Digital 5.1 CH" mark on the disc? Dolby Digital 5.1 CH Surround
Sound is produced only if the disc is recorded with 5.1 channel sound.
• Is the audio language correctly set to DOLBY DIGITAL 5.1-CH in the
information display?
• Is the remote control being operated within its operation range of angle and distance?
• Are the batteries drained?
• Have you selected the mode(TV/BD) functions of the remote control (TV or BD) correctly?
• Is the TV power on?
• Are the video cables connected properly?
• Is the disc dirty or damaged?
• A poorly manufactured disc may not be playable.
• Audio language and subtitles will not work if the disc does not contain them.
• Are you using a disc that does not contain menus?
• You can play 16:9 BD/DVDs in 16:9 Wide mode, 4:3 Letter Box mode, or
4:3 Pan - Scan mode, but 4:3 BD/DVDs can be seen in 4:3 ratio only.
Refer to the BD disc jacket and then select the appropriate function.
65