Table of Contents
Advertisement
Installing the Speakers on the Tallboy Stand
* HT-D553 only - Front Speakers
* HT-D555 only - Front/Surround Speakers
1.
Turn the Stand Base upside-down and connect it to the Stand.
2.
Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into
the four holes marked using a screwdriver as shown in the illustration.
!
CAUTION : When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged. (torque screw-
driver- below 15 kg.f.cm)
3.
Connect the upper Speaker to the assembled Stand.
4.
Insert another large screw (5*15, For connecting Speaker & Stand)
clockwise into the hole on the rear of the speaker using a screwdriver.
5.
This is the appearance after the speaker is installed. Follow this steps
to install other speaker.
1
Stand
Base
Stand
2
3
Speaker
Stand
4
5
1
English
Hide quick links:
Advertisement
Table of Contents
