Assembly; Fitting The Loop Handle; Assembling The Cutting Equipment; Fitting The Cutting Attachment Guard And Trimmer Head - Husqvarna 535FBX Operator's Manual

Fitting the loop handle

• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle.
• Fit the nut, knob and screw. Do not overtighten.
• Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
Assembling the cutting
equipment
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.

ASSEMBLY

Fitting the cutting attachment
guard and trimmer head
Fit the correct cutting attachment guard (A) for use with
the trimmer head.
Hook the cutting attachment guard onto the fitting on the
shaft and secure with the bolt (L).
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
Screw on the trimmer head (H) counter clockwise.
• To dismantle, follow the instructions in the reverse
order.
A
H
B
C
A
–
English 41