Chapter 2: Installation; Connecting Vhf And Uhf Antennas; Antennas With 300-Ohm Flat Twin Leads - Samsung LTM 225W Owner's Instructions Manual

06.CHAPTER2_EN 2/5/03 12:34 AM
2
C h a p t e r Tw o
I
N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that
look like this, see "Antennas with
300-ohm Flat Twin Leads", below.
If your antenna has one lead that looks
like this, see "Antennas with 75-ohm
Round Leads", on page 2.2.
If you have two antennas, see "Separate
VHF and UHF Antennas", on page 2.2.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has
300-ohm twin flat leads, follow the directions below.
2.1
C T : I
HAPTER WO NSTALLATION
Page 1
1
Place the wires from
the twin leads under
the screws on a 300-
75 ohm adaptor (not
supplied). Use a
screwdriver to tighten
the screws.
2
Plug the adaptor into
the TV ANTENNA
terminal on the
bottom of the back
panel.