Dimensions - Panasonic S-80MW1E5 Installation Instructions Manual

2-1. Exposed type
Preparation: Make 2 holes for screws using a screwdriver.
Mount the top case.
G Align the claws of the top
case and then align the
claws of the bottom case.
Cut here with
a nipper and
remove the burr
with a file.
Connect the remote control wiring
G Arrange the wires along the groove of the case.
2-2. Embedded type
Preparation: Make 2 holes for screws using a screwdriver.
Mount the top case.
G Align the claws of the
top case and then
align the claws of the
bottom case.
Avoid the
wire being
caught.
Claw
(2 places)
Connect the remote control wiring

6-3. Dimensions

Mount the bottom case to the wall.
Claw
(2 places)
Hole for
screw
Claw
Wood screw
(2 places)
(supplied)
Mount the bottom case to the wall.
G Pass the wire through the hole in the centre of
the bottom case.
Hole for
screw
Claw
Wood screw
(2 places)
(supplied)
(Unit: mm)
Wall to which
the remote
controller is
fixed
Top case
Bottom case
(Back side)
(Back side)
Top case
Bottom case
(Back side)
(Back side)
18
Clamper
(supplied)
Pass through
the hole
Remote controller terminal board
Remove the coating. Approx. 6 mm
Remove the sheath. Approx. 180 mm
Make sure the wiring connection is in
the correct direction.
Remote controller terminal board
Remove the coating. Approx. 6 mm
Make sure the wiring connection is
in the correct direction.