Installing The Charcoal Filter - GE PVM9179, PSA9120, PSA9240 Installation Instructions Manual

C4
MOUNT THE OVEN
3
Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.)
Cabinet Front
Cabinet Bottom Shelf
Self-Aligning Screw
Oven Top
4
Insert 3 self-aligning screws
( -28 x ) through outer
1 4
top cabinet holes. Turn two full
turns on each screw.
6 Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
7 Install grease filters. See the Owner's Manual
packed with the oven.
Installation Instructions
(continued)
Filler Block
This
Equivalent
distance
to Depth can NOT
exceed 2"
of Cabinet
to ensure
Recess
proper
installation
5
Tighten center
screw completely
C5
INSTALLING THE CHARCOAL
FILTER
1 Remove 2 screws on top of oven, just above
the grille panel, using a Phillips screwdriver.
2
Open the door.
3 Remove the grille. Slide the grille to the left then pull
out.
Grille
Insert the filter into the oven as shown until it fits
4
squarely into place. It will rest at an angle behind
the front lower tabs. When properly installed,
the wire mesh of the filter should be visible
from the front.
Charcoal filter installed
5 Replace the grille and the 2 top screws.
6
Close the door and replace left side screw.
22
Screws
Front lower tabs
Charcoal filter