Adjusting Fader Torque; Power Supply Unit Status Indicators - Sony MKS-8010A Operation Manual

Adjusting Fader Torque

You can adjust faders without removing them from the
center control panel or operation modules (Single fader
only).
Proceed as follows to adjust faders.
Fader lever
1
Pull the fader lever to an upright position between the
two holes on the fader cover.
2
Insert a hexagonal screwdriver or a hexagonal wrench
(4 mm sides) into one or both of the holes and rotate
to adjust the torque.
Rotate clockwise:
Fader lever operation becomes firmer.
Rotate counterclockwise:
Fader lever operation becomes freer.
Note
For a split fader, you cannot make adjustment from the
control panel surface. To make adjustment, it is necessary
to use the two holes provided in the back side of the
module.
If you want split fader torque to be adjusted, consult your
Sony service representative.
Single fader modules
MKS-8020A Standard Transition Module
MKS-8030A Key Frame Module
MKS-8032A DSK Fader Module
MKS-8027A Compact Transition Right Module
MKS-8028A Compact Transition Left Module
Split fader modules
MKS-8021A Simple Transition Right Module
MKS-8022A Simple Transition Left Module
MKS-8021ASC Simple Transition Compact Right
Module
MKS-8022ASC Simple Transition Compact Left Module
Power Supply Unit Status
Indicators
The power supply unit status indicators show the status of
the power supply unit during operation and when the unit
is powered on. Whenever a power error is detected, it is
reflected immediately by the indicator.
Hexagonal wrench
Indicator
color
Green
Red
−
Meaning of status indicator displays
Status Description
Lit Operating normally
LIt Power supply unit fan
fault
Not lit Power supply unit
fault
Adjusting Fader Torque / Power Supply Unit Status Indicators
Steps to take
−
Exchange the
fan unit
Exchange the
power supply
unit
19