Gasket; Vertical Brace - GE JK3800DH1BB Technical Service Manual

Gasket

All gaskets attach to oven front frames and are held
in place with pins.
To replace the oven gasket, start with the lower left
corner. Locate the two pins close to the overlap that
are about 1 3/4 in. apart. One pin will start on the
farthest left bottom hole. The next pin will be the
lowest left vertical hole. Continue up and around,
Gasket Spacing
Front Frame
Gasket Reinstallation

Vertical Brace

The vertical braces support the frame and contain
the hinge receivers.
Vertical Brace Removal
Replacement of vertical brace (SWO left side shown).
1. Remove power to the oven.
2. Remove the door assembly (See the Door
Assembly section in this guide for instructions).
3. Remove the upper oven.
4. Safely remove the oven from the installation.
NOTICE: Except where noted, all screws are 1/4 in.
hex head.
5. Remove the six T20 Torx screws from the top
front trim.
6. Remove the two T20 Torx screws from the lower
front trim.
7. If replacing the left side brace, remove the two
screws from the RJ-45 bracket.
8. Remove the two screws from the brace that
secures the microwave slide.
– 61 –
(Continued next page)