2-3-7.
IF-1242 Board/LCD Module
Note
The following parts are not reusable. when replacing the LCD module, prepare new parts in advance.
• LCD frame sheet
Preparation
1.
Remove the elbow assembly. (Refer to
2.
Remove the SW-1603 board/VR-351 board. (Refer to
Procedure
1.
Disconnect the three harnesses from the three connectors (CN200, CN301, and CN302) on the IF-1242 board.
2.
Remove the four screws to detach the IF-1242 board.
3.
Disconnect the VF cable from the connector (CN300) on the IF-1242 board.
VF cable
IF-1242 board
Harness
LCD module
Note
When installing the IF-1242 board, fit the two bosses with the two holes.
4.
Install the removed parts by reversing the steps of removal.
PMW-300
"2-3-4. Elbow
Assembly")
"2-3-6. SW-1603 Board/VR-351
Harness
P2 x 3
CN300
CN302
Hole
Board")
CN200
CN301
Hole
Harness
Boss
LCD frame sheet
Boss
2-16