Audio Adjustment; Setting The Clock; Volume Adjustment; Sleep Timer Function - LG LM-U1560 Owner's Manual

Audio Adjustment

Setting the CLOCK

Press CLOCK.
1 1
(If the clock requires setting, press and hold
CLOCK for more than 2 seconds.)
- The hours begin to blink.
Select a 24 hour cycle or 12 hour cycle by
2 2
turning MULTI JOG .
or
(12HR)
Press SET/CD [] to confirm the selected hour
3 3
cycle.
Use MULTI JOG to set the correct hours.
4 4
Press SET/CD []
5 5
Use MULTI JOG to set the correct minutes.
6 6
Press SET/CD [] and the correct time is shown
7 7
on the display.
Press CLOCK at any time briefly to see the
8 8
time.

Volume Adjustment

• Turn VOLUME CONTROL KNOB clockwise to
increase the sound level, or counterclockwise to
decrease it.
• Press VOLUME ( ) to increase the sound level, or
press the VOLUME ( ) to decrease it on the remote
control.
Headphone Socket
Connect a stereo headphone plug ( 3.5mm) into the
headphone jack.
The speakers are automatically disconnected when you
plug in the headphones (not supplied).

Sleep Timer Function

When the sleep timer is set, the unit automatically turns
off after the specified time has elapsed.
To specify the time delay before the power is
1 1
turned off, press SLEEP.
In the display window you can see SLEEP 180 for
about 5 seconds. This means that the system turns
off automatically after 180 minutes.
Each time you press SLEEP the setting
2 2
changes in the following order.
(24HR)
SLEEP 180 →150 → 120 →90→80→70 → 60→ 50 →
40 → 30 → 20 →10 → OFF (No display) →SLEEP 180...
To check the remaining time until the power is
3 3
turned off.
While the sleep function is active press SLEEP
briefly. The time remaining until the unit turns off is
displayed for about 5 seconds.
ote
If you press SLEEP while the sleep time is displayed,
the SLEEP time is reset.
To cancel Sleep Timer setting
If you wish to stop the function, press the SLEEP button
repeatedly until "SLEEP 10 " appears, and then press
SLEEP once again after "SLEEP 10 " shows on the
display.

Using Microphone

You can sing to a music source by connecting a
microphone to the unit.
Connect your microphone to the MIC socket.
1 1
" " will be shown in the display window.
Play the music you want.
2 2
Sing along with the accompaniment.
3 3
Adjust the microphone volume by turning MIC
VOLUME KNOB. (MIN - MAX )
otes
• When not using the microphone, set the MIC volume
knob to minimum or turn off the MIC and remove the
microphone from the MIC socket.
• If the microphone is set too near the speaker, a
howling sound may be produced. In this case, move
the microphone away from the speaker or decrease
the sound level by using the MIC volume control.
• If sound through the microphone is extremely loud, it
may be distorted. In this case, turn the MIC volume
control toward minimum.
9