Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 77

Table 2 has the following columns:
● Event
The "Event" column contains the following:
– Cold/Warm Start
– Link Change
– Authentication Failure
– Fault State Change
– IPSec VPN Logs
– Firewall Logs
– DDNS Client Logs
– System Connection Status
– System General Logs
– Digital In
– VPN-Tunnel
E-Mail
The device sends an e-mail. This is only possible if the SMTP server is set up and the
"SMTP client" function is enabled.
● Trap
The device sends an SNMP trap. This is only possible if "System > Configuration"
SNMPv1 Traps" is enabled.
● Log Table
The device writes an entry in the event log table, see "Information > Log Table"
SCALANCE S615 Web Based Management
Configuration Manual, 05/2015, C79000-G8976-C388-02
The device was turned on or restarted by the user.
This event occurs only when the port status is monitored and has changed, see
"System > Fault Monitoring > Link Change".
This event occurs when attempting access with a bad password.
The fault status has changed. The fault status can relate to the activated port
monitoring, the response of the signaling contact or the power supply monitoring.
An entry is made in the security log if the IPsec method for VPN was used.
Each time individual firewall rules are applied, this is recorded in the firewall log. To do
this, the LOG function must be enabled for the various firewall functions.
The event occurs when the DDNS client synchronizes the assigned IP address with
the hostname registered at the DDNS provider.
The connection status has changed.
Connection establishment, change to the configuration.
The event occurs when the status of the digital input has changed.
The event occurs when the status of VPN (IPsec, OpenVPN, SRC) has changed.
Configuring with Web Based Management
4.4 "System" menu
77