Initial Setup - Motorola SDC1000 Operating Manual

SDC1000

10. Initial Setup

Main Unit has Flash Memory to retain all setting values and when it delivered to customer there is no
data in the memory therefore Initial Setup is required for the first use.
10-1. Registration of RF Cards for RF CARD ONLY MODE
* This mode is only applicable when the extra proximity reader is connected.
¨ ç Turn switch on DC12V Power Supply.
All 3 LEDs will be flashing with starting sound.
¨ è Press 0 1 ENT from the keypad.(RF CARD ONLY MODE )
¨ é Present RF Cards as follow to register Master Card and User Access Cards.
Master Card
¨ ê First read card is registered as Master Card and the RF Cards followed to Master
Card are registered as User Access Cards then present Master Card again to finish
setup. (Please keep Master Card at the secure location for further setting changes.)
¨ ë Now, the Main Unit is entered to normal operation mode with default setting.
10-2. Registration of RF Cards with PIN for RF CARD + PIN MODE
* This mode is only applicable when the extra proximity reader is connected.
¨ ç Turn switch on DC12V Power Supply.
All 3 LEDs will be flashing with starting sound.
¨ è Press 0 2
ENT
¨ é Present RF Cards as follow to register Master Card and User Access Cards and type
4~6 digits Personal Identification Number(PIN) followed by each User Access Card.
Master Card
¨ ê First read card is registered as Master Card and the RF Cards+PIN
to Master Card are registered as User Access Cards with PIN numbers then present
Master Card again to finish setup.
(Please keep Master Card at the secure location for further setting changes.)
User Access Cards
from the keypad.(RF CARD + PIN MODE )
User Access Cards+PIN
SINGLE DOOR ACCESS CONTROLLER
........
Master Card(Finish setup)
........
Master Card(Finish setup)
ENT
- 10 -
MOTOROLA
followed
ENT