D-Link DSN-5000-10 Quick Start Manual page 3

6
Install Drives in the Expansion Array
Drives are installed from the front of the expansion array and
secured using the lever for each drive slot, just as drives are
installed in the DSN-5000 Series primary array. For more
information, see the DSN-5000 Series Hardware Reference Guide.
A.
On the front of the expansion array, select an open drive slot.
B.
Select the right type of drive for this drive slot, as described in
the DSN-5000 Series Hardware Reference Guide.
C.
Assemble the drive into the drive carrier according to the
instructions in the DSN-5000 Series Hardware Reference Guide.
D.
Hold the drive so the LEDs are on the left and the lever is fully
open. Then slide the drive into the drive slot until the lever starts
to close.
E.
Gently push the lever until it meets the latch on the left side of
the drive slot and clicks into place.
F.
Repeat this procedure to install additional drives.
Note: Be sure there are drive blanks in all drive slots that are
not occupied by a hard drive.
No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, or stored in a database or retrieval system, without the expressed written approval of D-Link, Inc. D-Link reserves the right
to make changes to this document at any time without notice and assumes no responsibility for its use. This document contains the most current information available at the time of publication. However, all of the features described in this document may not be currently
available.
7
Drive Enclosure LEDs
Each drive bay in the expansion array has a set of three LEDs.
The following table describes these LEDs.
LED Color Description
LED 1 Green This LED is reserved for future use.
LED 2 Green OFF = no drive is installed (drive slot is empty).
ON = drive is online, ready for operation.
Slow Flash = drive is being prepared for removal or is
being rebuilt.
Fast Flash = drive is being identified.
Amber Fast Flash = drive failed and should be replaced (see the
DSN-5000 User's Guide)
LED 3 Green Flash = drive activity is occurring.
Contact Information
For more information about the DSN-5000-10 Expansion Array
Web site: www.dlink.com
E
X
P
A
N
S
I
O
N
A
R
R
A
Y
Page 3