Samsung SV-A160X Service Manual page 19

Alignment and Adjustment
5-2-2 (b) IF THE NORMAL REMOTE CONTROL
ASS'Y OF X-7/X-8(DX7-R/DX7-RC/
DX8-R/DX8-RC) CHASSIS IS
AVAILABLE
Note 1 : Two kinds of remote control ass'y are used
for X-7/X-8(DX7-R/DX7-RC/DX8-R/
DX8-RC) chassis.
1. One is a normal remote control ass'y, the other is a
multi remote control ass'y
2. All adjustments are adjusted by normal remote
control ass'y only.
3. For the identification of normal remote control
ass'y and multi remote control ass'y, See page 5-1.
Note 2 : How to use the "TEST" button.
1. Disattach the inlay of remote control ass'y.
(See Fig. 5-1 and Fig. 5-2)
2. Press the "TEST" button with the pincers and the
precise driver as shown in Fig. 5-1 and 5-2)
1. When using the "INPUT" button of remote
control ass'y;
1) Simultaneously press the "INPUT" button and "1"
button in PB mode.
This will adjust the tracking center automatically.
2) Set the tracking preset using the "FINE(Tracking,
TRK)" button of remote control.
3) After adjustment is completed, press the
"POWER" button to release.
2. When using the "TEST" button of remote
control ass'y ;
1) Simultaneously press the "TEST" button and "5"
button in PB mode.
This will adjust the tracking center automatically.
2) Set the tracking preset using the "FINE (Tracking,
TRK) button of remote control.
3) After adjustment is completed, press the
"POWER" button to release.
5-4 Samsung Electronics