Cisco USC 3331 Quick Start Manual

Warning Read the installation instructions before you connect the system to its
power source. Statement 1004
Warning Installation of the equipment must comply with local and national
electrical codes. Statement 1074
Warning This product relies on the building's installation for short-circuit
(overcurrent) protection. Ensure that the protective device is rated not
greater than: 15A. Statement 1005
Warning In order to comply with FCC radio frequency (RF) exposure limits,
antennas should be located at a minimum of 7.9 inches (20 cm) or more
from the body of all persons. Statement 332
Note Use only with listed ITE equipment.
If you require assistance installing or operating your small cell, contact customer
support.
For warranty information, refer to:
http://www.cisco-servicefinder.com/WarrantyFinder.aspx
Cisco Systems, Inc.
www.cisco.com
Cisco has more than 200 offices worldwide. Addresses, phone numbers, and fax numbers are listed on the
Cisco website at www.cisco.com/go/offices.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks,
go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does
not imply a partnership relationship between Cisco and any other company. (1110R)
© Cisco Systems, Inc. All rights reserved.
78-21626-02 A0
C USC 3331 Q
ISCO UICK
1
Package Contents
Your Cisco Universal Small Cell (USC) 3331 is shipped with the
following:
• Power supply unit
• Ethernet cable
• This Quick Start Guide
2

Before You Begin

Consider where you want to place your new small cell. Place it on a flat
surface that is:
• somewhere central, away from windows so your small cell provides
the best possible coverage
• at least 30 cm (1 foot) from other wireless broadcasting devices to
avoid possible interference
• convenient to connect to your broadband router or cable modem
S G
TART UIDE