Table of Contents
Advertisement
Select this choice to view or change the start options, including the startup sequence, keyboard NumLock
state, PXE boot option, and PCI device boot priority. Changes in the startup options take effect when you
start the server.
The startup sequence specifies the order in which the server checks devices to find a boot record. The
server starts from the first boot record that it finds. If the server has Wake on LAN hardware and software
and the operating system supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that checks for a disc in the
CD-RW/DVD drive, then checks the hard disk drive, and then checks a network adapter.
This choice is on the full UEFI Setup Utility menu only.
• Boot Manager
Select this choice to view, add, delete, or change the device boot priority, boot from a file, select a
one-time boot, or reset the boot order to the default setting.
• System Event Logs
Select this choice to enter the System Event Manager, where you can view the error messages in the
system event logs. You can use the arrow keys to move between pages in the error log.
The system event logs contain all event and error messages that have been generated during POST, by
the systems-management interface handler, and by the system service processor. Run the diagnostic
programs to get more information about error codes that occur. See the Problem Determination and
Service Guide for instructions on running the diagnostic programs.
Important: If the system-error LED on the front of the server is lit but there are no other error indications,
clear the IMM system-event log. Also, after you complete a repair or correct an error, clear the IMM
system-event log to turn off the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error messages.
– IMM System Event Log
Select this choice to view the IMM system event log.
– Clear IMM System Event Log
Select this choice to clear the IMM system event log.
• User Security
Select this choice to set, change, or clear passwords. See "Using passwords" on page 56 for more
information.
• Save Settings
Select this choice to save the changes that you have made in the settings.
• Restore Settings
Select this choice to cancel the changes that you have made in the settings and restore the previous
settings.
• Load Default Settings
Select this choice to cancel the changes that you have made in the settings and restore the factory
settings.
• Exit Setup
Select this choice to exit from the Setup utility. If you have not saved the changes that you have made in
the settings, you are asked whether you want to save the changes or exit without saving them.
Using passwords
Use this information to set, change, or delete a power-on password.
56
BladeCenter HS22 Blade ServerInstallation and User's Guide
Advertisement
Table of Contents
