Page 1
DS-1TP00I Series Coaxial Power Unit User Manual UD02805B...
Page 2
Any and all information, including, among others, wordings, pictures, graphs are the properties of Hangzhou Hikvision Digital Technology Co., Ltd. or its subsidiaries (hereinafter referred to be “Hikvision”). This user manual (hereinafter referred to be “the Manual”) cannot be reproduced, changed, translated, or distributed, partially or wholly, by any means, without the prior written permission of Hikvision.
Page 3
INCIDENTAL, OR INDIRECT DAMAGES, INCLUDING, AMONG OTHERS, DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA OR DOCUMENTATION, IN CONNECTION WITH THE USE OF THIS PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Page 4
Coaxial Power Unit User Manual Regulatory information FCC information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
Page 5
Applicable Models This guide is applicable to the model listed in the following table. Series Model Coaxial Power Unit DS-1TP04I and DS-1TP08I Symbol Conventions The symbols that may be found in this document are defined as follows. Symbol Description Provides additional information to emphasize or supplement important points of the main text.
Coaxial Power Unit User Manual Safety Instructions Proper configuration of all passwords and other security settings is the responsibility of the installer and/or end-user. In the use of the product, you must be in strict compliance with the electrical safety regulations of the nation and region.
Coaxial Power Unit User Manual Chapter 1 Typical Application DS-ITP00I Series Coaxial Power Unit powers TVI POC (Power over Coaxial) cameras, and transmits analog TVI video signals, control signals and electric current from POC camera to DVR. POC Camera Coaxial Power Unit TVI(POC) CAMERA 1 TVI(POC)
Chapter 2 Physical Interfaces DS-1TP08I Rear Panel Figure 1-2 DS-ITP08I Rear Panel DS-1TP04I provides 4-ch video inputs and outputs. DS-1TP00I series is able to power POC camera. Video inputs and video outputs should be used in pairs like Camera1 and DVR 1 is a...
Chapter 3 Indicator Description Indicators in DS-1TP08I Front Panel Figure 1-3 DS-ITP08I Front Panel For DS-1TP04I, the front panel provides four channel indicators. The red power indicator indicates the power is on. Connect the POC camera to video input and the corresponding channel indicator...
Coaxial Power Unit User Manual Chapter 4 Operation Turn off the power switch before replacing the camera or DVR. For detail operation, please refer to 4.3 Replacing Camera and 4.4 Replacing DVR. 4.1 Starting up Step 1 Connect the power supply to the device. Step 2 Connect the camera to the video input and connect the DVR to the video output.
Coaxial Power Unit User Manual Only Hikvision POC cameras are supported. 4.4 Replacing DVR Step 1 Turn off the device according to 4.2 Shutdown. Step 2 Replace the DVR. Step 3 Turn on the power switch after the DVR has been replaced.