Casio 3262 Operation Manual

MA1104-EA
Keep the watch exposed to bright light
Bright Light
Solar cell
E-2
Contents
General Guide .......................................................................................................... E-6
Timekeeping ............................................................................................................. E-8
Alarm ...................................................................................................................... E-10
Stopwatch .............................................................................................................. E-13
Power Supply ......................................................................................................... E-14
Specifi cations ........................................................................................................ E-19
E-4
General Guide
Press B to change from mode to mode.
Pressing B after performing some operations in any mode returns to the
Timekeeping Mode.
Timekeeping Mode
E-6
Timekeeping
Minutes
Hour Seconds
PM indicator Day
Day of week
Charge indicator
E-8
Operation Guide 3262
The electricity generated by the solar cell of the watch is
stored by a built-in capacitor. Leaving or using the watch
where it is not exposed to light causes the capacitor to run
down. Make sure the watch is exposed to light as much as
possible.
When you are not wearing the watch on your wrist, position
the face so it is pointed at a source of bright light.
You should try to keep the watch outside of your sleeve as
much as possible. Charging is reduced signifi cantly if the
face is only partially covered.
Alarm Mode
B
In the Timekeeping Mode, press C to switch between
the 12-hour and 24-hour formats.
When the 12-hour format is selected, the indicator PM
appears on the display to indicate "p.m." times. There is
no indicator for "a.m." times.
When the 24-hour format is selected, the indicator 24H
appears on the display.
A charge indicator appears on the display of this watch
when charging is required.
Getting Acquainted
Congratulations upon your selection of this CASIO watch.
Expose the watch to bright light to charge its capacitor before using it.
You can use this watch even as its capacitor is being charged by exposure to
bright light.
Be sure to read "Power Supply" on page E-14 of this manual for important
information you need to know when exposing the watch to bright light.
About This Manual
Procedure Lookup
The following is a handy reference list of all the operational procedures contained in
this manual.
To set the time and date ......................................................................................... E-9
To set the alarm time ............................................................................................. E-10
To stop the alarm ................................................................................................... E-11
To turn the Daily Alarm and Hourly Time Signal on and off .............................. E-12
To test the alarm .................................................................................................... E-12
To measure times with the stopwatch ................................................................. E-13
If you do not perform any operation for a few minutes in the Alarm Mode or Setting
Screen, the watch automatically reverts to the Timekeeping Mode.
Stopwatch Mode
B
To set the time and date
Flashing
3. While the seconds setting is selected (fl ashing), press
press C while the seconds setting is in the range of 30 to 59, the seconds are
reset to 00 and 1 is added to the minutes. If the seconds setting is in the range of
00 to 29, the minutes count is unchanged.
4. While any other setting is selected (fl ashing), press
Holding down C changes the setting at high speed.
5. After you set the time and date, press
Button operations are indicated using the letters shown
in the illustration.
To ensure that this watch provides you with the years of
service for which it is designed, be sure to carefully read
and follow the instructions under "Operating Precautions"
and "User Maintenance".
Setting Screen
B
B
B three times in the Timekeeping Mode to display
1. Press
the setting screen.
A to move the selection (fl ashing) in the following
2. Press
sequence.
A A
Seconds Hour
A
Day of week Day
A A
C to reset it to 00. If you
C to increase the number.
B to return to the Timekeeping Mode.
E-1
E-3
E-5
E-7
Minutes
A
Month
E-9