18
Installing the machine
To install the machine:
• Remove the transport packaging
• Remove the front panel.
• Remove the machine from the transport pallet
and locate it on the bolts.
is lifted off the pallet: Make sure that the
machine does not come down on the floor
with either of the rear corners first. The side
panel of the machine can be damaged.
ways lift the machine by the chassis, never by
the door or door handle.
• Check that the machine is level and steady in
17
all four corners mounting points. Adjust the
level by using stainless or galvanized steel
washers between the machine and the floor.
The washers must be of a size to cover the
support surface.
• Fit the washers and self-locking nuts supplied
18
with the machine and tighten well.
• To tighten the nuts we recommend to use
19
a rachet wrench, especially in the right rear
corner.
After the machine has been in use for a while,
check and re-tighten the nuts if necessary.
Installation
When the machine
Al-
17
18
19
546
5464
5951, 5952