Installation and Wiring
3.1.5 GT707 Installation Method
Secure the GT to the installation panel using the fittings and screws (4 sets/per unit) provided
with the unit.
PROCEDURE
1. Place the GT unit in the installation panel.
2. Insert the fittings into the grooves of the GT unit, and slide them to be fixed.
3. Tighten the screws [M3 (Length: 16 mm)] to secure the GT unit to the
installation panel.
(Enlarged view)
The cross slot screwdriver of #2 must be used.
•
•
The tightening torque of the screw [M3 (Length: 16 mm)] should be 0.2 to
0.3 N·m. Tightening the screws too hard can cause deformation of the front
panel, so that the touch switches will not function properly.
3-4