Table of Contents
Advertisement
I
Quick Start Recording (QSR) timer
I
Timer recording
IS simple.
You can start
a recording and then programme when the VCR
is to stop recoding
and go to stand-by mode automatically.
Press the
REC buttons to start recording.
Press the
REC
buttons again and the
"OFF- -:- -"
indication
will start flashing on the VCR display.
OFF
.
#..&
----
Within 10 seconds, set the recording end time by using the
. REC and (A or V) buttons.
*
•1
Each press of the.
REC buttons will advance the recording
end time by units of 30 minutes.
Each
press of the (A) button willadvance the recording
end
time by units of 1 minute.
Each press of the (7) button will retard the recording end
time by units of 1 minute.
To stop the recording
at any time, press the
STOP
button.
Checking/Changing
When the
REC buttons are pressed during QSR recording,
the retarding
end time will blink for 10 seconds.
The recording end time can be changed by pressing the
. REC and (A or 7) buttons during this 10-second period.
[
Other recording possibilities
If you wish to avoid recording
unwanted
material
1.
During recording,
press the 11
PAUSE/STILL
button.
The lV picture and sound will not be recorded.
2. Press the II
PAUSE/STILL buttonor
REC
buttons, and
the recording will resume.
Note:
If the record pause mode continues for about five
minutes, the
VCR
will automatically
go into the stop
mode in order to prevent damage to the tape:
Recording
one programme
while watching
another
1.
Start recording the desired TV programme
selected on the
VCR.
2. Press the VTRKV
button to erase
"WR"on
the VCR
display.
3. Select on the TV receiver the programme
you want to
watch.
I
Blank search function
I
The blank search function automatically
searches for the
beginning of the next blank (unrecorded)
portion of the tape,
and stops the VCR at that position. This is convenient
when
you want to continue recording at the end of a previous
recording.
[n the stop or playback mode, press the INDEX button.
I
Press the F
PLAY button.
The blank search function will start.
Notes:
If starting in a recorded portion of the tape, the VCR will
look for a blank toward the end of the tape. (lhe end of the
recorded portion.)
If starting in an unrecorded
portion of the tape, the VCR will
look toward the beginning
of the tape for the beginning
of
the unrecorded
portion.
The stopping position may vary slightly. Play back a few
seccmds of the tape to make sure it is at the position you
want.
This function may also stop the VCR during slight pauses
(unrecorded
portions) between taped programmed.
Advertisement
Table of Contents
