Help - Motorola MBP994CONNECT User Manual

8. Help

Display
No display
• Try recharging or replacing the battery pack.
• Reset the Units. Disconnect the battery pack of the Parent
Unit and unplug both the Units' electrical power, then plug
them back in.
• Is the Unit switched on?
Press and hold the ON/OFF button 0 on the Parent Unit to
switch it ON.
• Is the correct camera selected? Change the camera number, if
necessary.
• Is the video display turned on? Press the VIDEO ON/OFF
button V to turn it ON.
• When operating using batteries only, the display will go blank after
5 minutes or 30 minutes or 60 minutes to save power (depending
on video settings). The Unit is still active and will give you audio
alerts. You can reactivate the screen by pressing any button.
Registration
If the Baby Unit has lost its link with the Parent Unit
• Try recharging or replacing the battery pack.
• If the Baby Unit is too far away it may be going out of range,
so move the Baby Unit closer to the Parent Unit.
• Reset the Units by disconnecting them from electrical power.
Wait about 15 seconds before reconnecting. Allow up to one
minute for the Baby Unit and the Parent Unit to synchronise.
• See 2.4 "Registration (Pairing)" , if there is a need to
re-register the Units.
Interference
Noise interference on your Parent Unit
• Your Baby and Parent Units may be too close. Move them
further apart.
Help 43