Sharp LC-50U35T Service Manual page 18

LC50/58/65U35T
Writing the Panel size, volume, type and destination
1) Enter the adjustment process mode
2) Point the cursor to [PANEL SIZE]
3) Select Panel Size and press [enter] key
4) "OK" is displayed
5) Point the cursor to [VOLUME TYPE]
6) Select Volume Type and press [enter] key
7) "OK" is displayed
8) Point the cursor to [INDUSTRY INITIAL]
9) Select Destination and press [enter] key
10) "OK" is displayed
Volume
Type
10. FACTORY SETTING
AC power is plug off after shipment setting is done.
Caution: Do not plug on again after shipment setting is done. If do, please re-do the shipment setting.
T I E M
Factory setting AC power off to exit the
factory setting.
50U35T 58U35T
0 1
C O N D I I T O N
Move cursor to [INDUSTRY INIT] on 2
NO to YES, then press [ENT].
Version confirmation screen is displayed on the green screen, if
[SUCCESS] is displayed on the top side, it is complete.
Power AC OFF.
The followings are initialised to factory setting
65U35T
2
P R O C E D
1) User Setting
2) Channel Data (broadcast frequencies etc.)
3) Password Setting Value
4) Operating Hours
5) Standby Cause
6) Auto Installation Flag
5 – 10
U R E
nd
page, change the option from