Cisco PA-100VG Installation And Configuration Manual page 7

•
Handle carriers by available handles or edges only; avoid touching the printed circuit boards or
connectors.
•
Place a removed component board-side-up on an antistatic surface or in a static shielding
container. If you plan to return the component to the factory, immediately place it in a static
shielding container.
•
Avoid contact between the printed circuit boards and clothing. The wrist strap only protects
components from ESD voltages on the body; ESD voltages on clothing can still cause damage.
•
Never attempt to remove the printed circuit board from the metal carrier.
Caution
be between 1 and 10 megohms.
What Is the 100VG Port Adapter?
This section contains information specific to the 100VG port adapter and its use with Cisco 7000
series, Cisco 7200 series, and Cisco 7500 series routers.
The following sections discuss information specific to the 100VG port adapter:
•
100VG Port Adapter LEDs, page 8
•
100VG Port Adapter Interface Receptacles, Cables, and Pinouts, page 9
•
Port Adapter Locations on the VIP2 and in the Cisco 7200 Series Router, page 9
Each 100VG port adapter provides a single interface ports, which is compatible with and specified
by IEEE 802.12, to provide 100-Mbps interface over Category 5, unshielded twisted-pair (UTP)
cable (with RJ-45 connectors), supporting 802.3 Ethernet packets. The 100VG port adapter operates
at 120 Mbps with a 5B/6B coding scheme, which provides a data rate of 100 Mbps.
Note
for a maximum aggregate bandwidth of 100 Mbps per 100VG interface.
The 100VG port adapter is designed to conform to the following emissions standards: FCC Part 15
Class A, Cispr22 Class A, EN 55022 Class A, and VCCI Class 1.
The PA-100VG port adapter can be monitored with the IEEE 802.12 Interface MIB
(DOT12-IF-MIB.my). (For information on accessing Cisco MIB files, refer to the Cisco MIB User
Quick Reference.)
For safety, periodically check the resistance value of the antistatic strap. The measurement should
The 100VG interfaces on a 100VG port adapter can be configured at 100 Mbps, half duplex
PA-100VG AnyLAN Port Adapter Installation and Configuration
What Is the 100VG Port Adapter?
7