Table of Contents
Advertisement
Message
Check address
Disk full on the
Server
Check address.
No messag
It is generated the
error by the cause of
the servers end.
There is already
files of this name.
The Over write
prohibition is set.
4.3.6 FTP Transmission errors
<FTP transmission error message and error code list>
Message
Error
code
No message
#022
Transmission
#099/ #995 - Transmission cancelled by user.
cancelled
HD full
#702
HD full
#703
Address does not
#704
appear in address
list.
Address table not
#706
available
No response
#751
TCP/IP error
#755
Error code Cause
#804
- No match for specified directory name.
- In SMB, a user exists but no write privileges.
#805
#806
- Wrongly specified user name.
- Wrongly specified password. (Excl. Windows
NT.)
#807
No access rights for the specified directory
#808
#809
Cause
Address deleted or invalidated during transmission
reservation.
Operation stopped because HD full (work area).
Operation stopped because HD full (image area).
- An error occurred when address information was being
obtained from the address list. (Address deleted from list after
scanning, etc. )
- Address table being imported/ exported from RUI.
- Address book usage doubled up with other transmission
component (Fax, etc.).
- Server has not booted up.
- Network disconnected. (If connection cannot be made with
transmission destination, connection is sometimes cut mid-
way.)
- No Tree name entered.
- Reset caused by internal error. Processing interrupted.
- IP address set to 0.0.0.0. In the following two situations, the
IP address is 0.0.0.0.
1) Address could not be obtained from DHCP, BOOTP,
RARP.
2) Unit launched in IP fixed mode(keys 1+7 to enter
FIXIPmode).
- TCP/IP protocol stack resources insufficient. Even with
internal retry (5 times), transmission failed.
Remedy
- Check that the destination directory name is correct.
- Set directory access privileges in the server.
-Document deletion of server
- Change address book user name or password.
- Check the access rights to the server.
- The server is reset.
-It sets it to possible Over write on server.
T-4-8
Remedy
- Retransmit deleted address.
- Check that a group address is specified as the transfer destination
and that it contains a valid address.
- Check that a group address is specified as the transfer destination
and whether it contains local print or fax box only.
- Check whether the specified transfer destination address has
been deleted.
Resend.
- Wait a while then retry. Stop broadcast transmission with other
protocols. This sometimes helps to avoid this problem.
- Wait a while then retry. Stop broadcast transmission with other
protocols. This sometimes helps to avoid this problem.
- Check address list settings. Or, turn unit OFF/ON.
- Quit access from RUI.
- Wait a while and then retry
- Check transmission destination and network settings.
- Enter Tree name.
- Transmission jobs whose processing has stopped for some reason
or other are forced to quit by assigning an internal error code
(#751). As a result, after rebooting, the job is not run.
- Set the IP address correctly or set DHCP, RARP, BOOTP
environments to operate properly.
- Turn power OFF/ON.
Chapter 4
0020-7989
4-23
Advertisement
Table of Contents
