Table of Contents
Advertisement
Dismantling of the DVD Module
1) Loosen 3 screws "L" at the power PCB bracket bottom to remove DVD module as shown in fi gure 13.
Dismantling of the VFD+LED+DVD LED PCB
1) Loosen 3 screws "M" on the VFD PCB to remove it as shown in fi gure 14.
2) Loosen 2 screws "N" on the LED PCB to remove it as shown in fi gure 15.
3) Loosen 2 screws "O" on the door LED PCB to remove it as shown in fi gure 16.
4) Loosen 2 screws "P" at the DVD door lens ass'y to remove it as shown in fi gure 17.
5) Loosen 4 screws "Q" at the touch PCB bracket as shown in fi gure 18
M
Figure 14
O
Figure 16
3 - 3
L
Figure 13
N
Figure 15
P
Figure 17
Q
Figure 18
SERVICE POSITIONS
Note:In some service positions the components or copper patterns of one board may risk touching its neighbouring pc boards or
metallic parts. To prevent such short-circuit use a piece of hard paper or other insulating material between them.
3 - 3
Advertisement
Table of Contents
