Table of Contents
Advertisement
7. MA: MA is the Reader#1 (Built-in Reader) Operating Mode for the cardholder. If you put '1' for MA,
Reader#1 is always operating on RF Only Mode.
8. MB: MB is the Reader#2 (Exit Reader) Operating Mode for the cardholder. If you put '1' for MB,
Reader#2 is always operating on RF Only Mode.
9. LV: LV is the Output Operating Level for the cardholder. Output
T
o setup Output operating time for each level, refer to the Output Setting on the [F7 SETUP MENU].
10. FP: FP is the Fingerprint Usage Flag (1 digit). You can assign the user who uses fingerprint or not.
9.4.2 ID DELETION
☞ Registered ID will be deleted in the controller by presenting the card or input the ID number from the keypad.
.
Present the card to be deleted. The ID number will appear on the LCD. If you don't have the card, input 8digit
ID
number and <ENT> key from the keypad. If the ID number is found, the ID will be deleted and display "ID
DELETED"
. If the ID number is not found, the display will show " UNREGISTERED ID". You may repeat ID
D
ELETION many times.
'0' – System Operating Mode [F2 SETUP MENU]
'1' – ID Only Mode
'2' – ID + Finger Mode
'3' – ID + Password + Finger Mode
'0' – System Operating Mode [F2 SETUP MENU]
'1' – ID Only Mode
'2' – ID + Password Mode
'0' or '1' – Level #1
'2' – Level #2
'3' – Level #3
'4' – Level #4
'0' – User without Fingerprint
'1' – User with Fingerprint
operating time can be set for each user.
44
[READER#1 MODE]
[READER#2 MODE]
Advertisement
Table of Contents
