Mitsubishi Electric AJ65BTS-RPH User Manual page 32

(1) Tighten module installation screws within the torque range below.
Do not over-tighten these screws. The screws and module case may be
damaged.
Table 4.1 Specified torque range for each screw
Screw location
Module installation screw (M4 screws)
Terminal block fixing screw
(2) When a DIN rail is used, install it taking care with the following.
(a) Applicable DIN rail type (conforming to IEC 60715)
TH35-7.5Fe
TH35-7.5Al
(b) Intervals of DIN rail mounting screws
Mount the DIN rail by fixing it with mounting screws at intervals of 200
mm (7.87inch) or shorter.
(3) To mount the AJ65BTS-RPH to the DIN rail, hitch the upper hook of the
module to the DIN rail securely and push the module into the DIN rail.
(Push the module until the lower hook of the module clicks.)
DIN rail
(4) When installing the AJ65BTS-RPH module on the control panel, to
improve the ventilation and facilitate the replacement of the module,
provide a distance of 60 mm (2.36inch) or longer between the upper and
lower surfaces of the module and the structural members or parts.
(5) Install the AJ65BTS-RPH module on a flat smooth surface.
If there are irregularities on the installation surface, undue force may be
applied to the printed circuit boards, and the boards may be damaged.
Specified torque range
0.78 to 1.08N•m
0.4 to 0.5N•m (conforming to IEC 60999)
22