NETGEAR WGT624 v4 User Manual page 24

Super G Wireless Router WGT624 v4 User Manual
3. Select the region in which the wireless router will operate.
4. Set the channel. The default channel is 6.
This field determines which operating frequency is used. It should not be necessary to change
the wireless channel unless you notice interference problems with another nearby wireless
router or access point. Select a channel that is not being used by any other wireless networks
within several hundred feet of your router. For more information about the wireless channel
frequencies, click the link to the online document
5. Set the mode to specify which 802.11 data communications protocol is used. For more
information about the mode, see
6. For Security Options, select None.
7. To save your changes, click Apply.
Note: If you are configuring the router from a wireless computer and you change the
router's SSID, channel, or security settings, you will lose your wireless
connection when you click Apply. You must then change the wireless settings
of your computer to match the router's new settings.
8. Select Wireless Settings under Advanced in the main menu of the wireless router.
Figure 1-7
9. Make sure that the Enable Wireless Router Radio and Enable SSID Broadcast check boxes
are selected.
10. Click Setup Access List.
1-10
"Wireless Communications" in Appendix
"Viewing or Change Wireless Settings" on page
v1.0, July 2008
2-5.
Configuring Internet Connectivity
B.