Show Ip Arp Inspection Vlan - Cisco Nexus 5500 Series Command Reference Manual

Chapter Show Commands

show ip arp inspection vlan

To display the Dynamic ARP Inspection (DAI) status for the specified list of VLANs, use the show ip
arp inspection vlan command.
Syntax Description vlan-list
Command Default None
Command Modes
Any command mode
Command History Release
5.0(3)N1(1)
Examples This example shows how to display the DAI status for VLAN 1:
switch# show ip arp inspection vlan 1
Source Mac Validation
Destination Mac Validation : Enabled
IP Address Validation
Vlan : 1
-----------
Configuration
Operation State
switch#
Related Commands Command
clear ip arp inspection
statistics vlan
ip arp inspection vlan
show ip arp inspection Displays the DAI configuration status.
show ip arp inspection
interface
show running-config
dhcp
OL-27883-02
show ip arp inspection vlan vlan-list
List of VLANs that have the DAI status. The vlan-list argument allows you to
specify a single VLAN ID, a range of VLAN IDs, or comma-separated IDs and
ranges. Valid VLAN IDs are from 1 to 4094.
Modification
This command was introduced.
: Disabled
: Inactive
Description
Clears the DAI statistics for a specified VLAN.
Enables DAI for a specified list of VLANs.
Displays the trust state and the ARP packet rate for a specified interface.
Displays DHCP snooping configuration, including the DAI configuration.
: Enabled
: Enabled
Cisco Nexus 5500 Series NX-OS Security Command Reference
show ip arp inspection vlan
287