Adding A Drive To A Dense Intermix Drive Tray - Hitachi G200 Service Manual

7. In the maintenance utility, click Hardware > Controller Chassis
Hardware > Drive Box.
8. Click the Drives tab.
9. Confirm that the status of the drive to be replaced is Normal.
If necessary, click Refresh to update the status in the window.
10. Confirm that the red ALM LED is off at the new drive.
11. Attach the front bezel.

Adding a drive to a dense intermix drive tray

The numbering of the drive slots in the dense intermix drive tray begins with
0 to 59 and reads from left to right.
When working on a dense intermix drive tray:
• Be mindful of other workers nearby.
• Exercise care when removing or storing the dense intermix drive tray.
• Do not remove multiple dense intermix drive trays all at once because the
rack can fall over.
• Do not put any objects on the removed dense intermix drive tray.
• Do not use the dense intermix drive tray as a work space because the rack
can fall over.
• Remove the dense intermix drive tray from the rack and remove the top
cover.
• Use only DKC-F810I-1R6FN, DKC-F810I-3R2FN, and DKC-F810I-6R4FN
drives when installing flash module drives.
Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• Confirm that the storage system power is turned on.
Procedure
1. Pull up the stopper of the drive handle toward you to release the lock.
2. Open the handle toward you, and then gently remove the drive to be
replaced.
Handle the drive with care.
3. Wait at least 30 seconds. Then place the new drive into the guide rail and
slide it gently in the direction of the arrow.
4. Push the drive until it snaps into place.
Replacing a drive
Service Guide for VSP Gx00 and VSP Fx00 Models
117