Related Manuals for Samsung IFA-E
Summary of Contents for Samsung IFA-E
- Page 1 Ethernet user manual Model Front picture Rear picture name IFA-E SRP-350 SRP-350II SRP-270 IFB-E SRP-370 SRP-372 V3.0.0 www.samsungminiprinters.com...
- Page 2 1) Interface version: V3.x.x 2) Difference of IFA-E and IFB-E: All features are same. Only a writing direction of model name on metal bracket is reverse. It is because of reverse position of the main board of SRP-350 and SRP-370.
- Page 3 4. Ethernet interface card setup 1) Check the Ethernet interface card version and select the right tool file. V3.x.x is the latest version. Turn off the printer and install Ethernet interface card. 3) Set a serial communication speed at the highest bps. - SRP-350: 57,600bps - SRP-370, 372, 350II: 115,200 bps - SRP-270: 19,200 bps...
- Page 4 6) Select “Search”. If you know IP address check in the box of “Direct configuration” and enter IP address. Then select “search”. V3.0.0 www.samsungminiprinters.com...
- Page 5 7) Select MAC address at “Board list”. 8) Enter IP Address, Subnet mask, Default Gateway according to your Sub environment. - Caution: There is no Gateway when the printer is connected to PC direct. Write the Same with IP address at Gateway address. - Notice: Ethernet interface requests Gateway device to save its own IP address when Data transmission does not take place for more than 5 minutes...
- Page 6 5. Standard TCP/IP port addition It is used when application program works with printer driver. Applicable operating systems Win 2000, XP, 2003 server. Follow the Installation procedure below if required. 1) Install printer driver 1-1. Download and install the printer driver from homepage. www.samsungminiprinters.com 1-2.
- Page 7 3) Select “Ports” and click the button “Add Port” 4) Select “Standard TCP / IP port” and choose “New Port” V3.0.0 www.samsungminiprinters.com...
- Page 8 5) Go next when Standard TCP/IP Printer Port Wizard activated. 6) Write IP address at box “Printer Name or IP Address” and go next. - IP address in this case must be the same as the value given to Ethernet card. V3.0.0 www.samsungminiprinters.com...
- Page 9 7) Go next. 8) Select “Close” V3.0.0 www.samsungminiprinters.com...
- Page 10 9) Click the button “Configure Port” 10) Enter “Port Number” and OK. - It must be same as the value given to Ethernet card. V3.0.0 www.samsungminiprinters.com...
- Page 11 11) Go Apply. 12) Select General / Print Test Page and check whether print is okay. V3.0.0 www.samsungminiprinters.com...
- Page 12 [Attachment 1] “Printer dipswitch setting” Printer Baud rate(bps) Hand shaking & parity Model SW1-7 SW1-8 57600 DTR/DSR:SW1-3 off SRP-350 38400 8 data bit: SW1-4 off none parity: SW1-5 off 19200 9600 SW2-7 SW2-8 19200 DTR/DSR: SW2-3 off SRP-270 9600 8 data bit: SW1-4 off none parity: SW1-5 off 4800 2400...