Install The Switch In The Rack - Cisco Catalyst 5509 Quick Installation Manual

2
Rack-Mount the Switch (continued)

Install the switch in the rack

Note: Three people are required to install the switch in an open rack. To make the switch
easier to lift, remove the power supplies and modules before installing the switch in the rack.
1
Position one person on each side of the chassis. Lift the switch and position it on the shelf
brackets and crossbar.
2
Align the mounting holes in the L brackets with the mounting holes in the rack.
3
Have the third person secure the chassis by inserting the mounting screws through the holes
in the L brackets and into the threaded holes in the mounting posts.
4
Use a tape measure and level to ensure the chassis is installed straight and level.
4
FAST ETHERNET SWITCHING MODULE
FAST ETHERNET SWITCHING
MODULE
FAST ETHERNET SWITCHING
MODULE
FAST ETHERNET SWITCHING FAST ETHERNET SWITCHING MODULE
MODULE
FAST ETHERNET SWITCHING
MODULE
o
o
AC FAN OUTPUT
OK
OK FAIL
AC
FAN OUTPUT
OK OK
FAIL
L bracket
WS-x5530
100%
1
SUPERVISOR ENGINE I I I
CONSOLE AUX 0%
Switch Load PCMCIA
WS-x5530
100%
2
SUPERVISOR ENGINE I I I
CONSOLE AUX 0%
PCMCIA
Switch Load
3
FAST ETHERNET SWITCHING MODULE
FAST ETHERNET SWITCHING MODULE
FAST ETHERNET SWITCHING MODULE
FAST ETHERNET SWITCHING
MODULE
FAST ETHERNET SWITCHING MODULE
FAST ETHERNET SWITCHING FAST ETHERNET SWITCHING
MODULE MODULE
FAST ETHERNET SWITCHING
MODULE
o
AC FAN
OUTPUT
OK OK
FAIL
WS-U5531-FETX
MDIX PORT 2
MDIX
10/100Mbps
10/100Mbps
LINK LINK
EJECT
10/100 FAST ETHERCHANNEL
WS-U5531-FETX
MDIX PORT 2
MDIX
10/100Mbps
10/100Mbps
LINK
LINK
EJECT
10/100 FAST ETHERCHANNEL
o
AC FAN OUTPUT
OK
OK FAIL