Cisco ASR 900 Series Configuration Manual page 97

Configuring Multi Router Automatic Protection Switching
Command or Action
Step 4
redundancy
Example:
Router(config)# redundancy
Step 5 interchassis group group-id
Example:
Router(config-red)# interchassis group 50
Step 6 member ip ip-address
Example:
Router(config-r-ic)# member ip 60.60.60.2
Step 7 monitor peer bfd
Example:
Router(config-red)# monitor peer bfd
Step 8
exit
Example:
Router(config-r-ic)# exit
Step 9
controller SONET slot/bay/port
Example:
Router(config)# controller SONET 0/5/2
Step 10
framing [SDH | SONET]
Example:
Router(config-controller)# framing SONET
Step 11 clock source internal
Example:
Router(config-controller)# clock source
internal
Step 12 sts-1 1-3POS
Example:
Router(config-controller)# sts-1 1-3
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
Configuring protect node for POS MR-APS
Purpose
Enters the redundancy configuration mode.
Configures an interchassis group within the redundancy
configuration mode and enters the interchassis redundancy
mode.
Configures the IP address of the peer member group.
Enables BFD on the POS link.
Exits the redundancy mode.
Selects and configures a SONET controller and enters
controller configuration mode.
• slot—Chassis slot number, which is always 0.
• bay—Card interface bay number in a slot. The range
is from 0 to 5.
• port—Port or interface number. The range is from
0 to 7 for Gigabit Ethernet.
Configures the controller with framing type. SONET
framing is the default option.
Sets the clocking for individual E1 links.
Specifies the STS identifier.
89