Table 2-4 Parameters For The Addport Command - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 2 Provisioning Communications Links
ImaGrp PortType Conf
------ -------- ----- -----
1.1
NextPortNumAvailable:
ImaGrp
------
1.1
Syntax : dspports
PXM1E_SJ.1.1.AUSMB8.a >
In the list of ports shown above, the port numbers configured on the AUSM card are shown in the Port
column. The port numbers in the Port column appear in the format slot.port, so the port number is the
number that appears after the period. When you add a port, you must specify a unique port number. For
example, if port number 2 is assigned to line 2, you cannot use port 2 on any other line on that AUSM
card.
Notice the list of IMA groups shown in the previous example. An IMA group serves as a single ATM
port operating over multiple physical lines. When you assign a group number to an IMA group, that
number serves as the ATM port number. Therefore, you cannot use the same number for both an ATM
port and an IMA group.
To add a Frame Relay port to an AUSM card, enter the following command:
Step 4
PXM1E_SJ.1.1.AUSMB8.a > addport <port_num> <port_type> <line_num>
Table 2-4
Table 2-4
Parameter
or Option
port_num
port_type
line_num
The following addport command example defines ATM port 7 as a UNI port on line 7.
PXM1E_SJ.1.1.AUSMB8.a > addport
PXM1E_SJ.1.1.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Avail
rate rate
NNI 14364 14364
3
Sync State
----------
Far-End Permanent
lists and describes the addport command parameters.
Parameters for the addport Command
Description
Port number for the ATM service. The port number range is 1 to 8.
The available port numbers are shared by ATM ports and IMA groups. If a port
Note
number is in use as either an ATM port number or as an IMA group number, that
port number cannot be used for other ATM ports or IMA groups.
Type of ATM service:
UNI = 1
•
• NNI = 2
Line number to which the port definition applies. The line number range is 1 to 8.
If a line is assigned to an IMA group, you cannot use that line for an ATM port
Note
unless you remove the line from the IMA group.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Lines configured Lines present
--------------- --------------- --------- ----------
1.2.3.4 1.2.3.4
7 1 7
General AUSM Provisioning Procedures
Tol Diff Port State
Delay(ms)
275 Active
2-11