Troubleshooting (In Operation); Appendix; Contents Of The Getting Started Manual; Replacing Square-Button Labels - Yamaha NUAGE MASTER Ncs500-CT Operation Manual

Troubleshooting (in
operation)
A connection cannot be
established with Pro Tools.
• Ensure that the steps described in "Settings for Pro
Tools" (page 48) have been completed.
• If using a wireless LAN adaptor, try turning it off.
Values cannot be entered by
touching parameters shown on the
[Multi function display].
• Ensure that [PARAM] (page
section has been turned on for the parameters in
question.
19) from the NUMERIC PAD

Appendix

Contents of the Getting
Started Manual
PRECAUTIONS
NOTICE
Information
Introduction
A Message from the Development Team
Included Accessories
Items to Have Ready
How to Read the Manual
Setup
Overall Process
Setting and Connecting
Setting up the Power Supply
Installing TOOLS for NUAGE
Configuring the Workgroup on NUAGE
Troubleshooting (in setting up)
Appendix
Contents of the Operation Manual
Firmware Updates
Adjusting the Touch Sensitivity
Specifying the Brightness
Calibrating Detection Point of the Touch Screen
Resetting to the Factory Default Condition
Dimensions
Specifications
Replacing Square-button
Labels
The labels from the square buttons can easily be
replaced. These replacements can be made by cutting a
transparent or semi-transparent sheet into 10 x 10 mm
pieces. To install, simply remove the button's cap, swap
out the current label, and replace the cap.
NUAGE MASTER Operation Manual

Troubleshooting (in operation)

47