HP 9000 Installation Manual page 17

D class and r class internal peripherals enterprise servers

Hide thumbs Also See for 9000:

I. Install Removable

Removable media drive, such as CD-ROMs, or DDS and quarter-inch

Media Drives

cartridge tapes, can all be installed in the first two full size slots

underneath the IDE floppy drive slot.

NOTE

A DDS tape drive should be installed in the lower slot of the removable

media bracket. The upper slot may contain a second DDS drive, a CD-

ROM drive, or a quarter-inch tape drive.

If devices are already installed in the removable media bracket, you

must remove the metal EMI shield from the rear of the removable media

bracket and disconnect all data and power cables from the devices before

performing the following procedure.

1. Remove four (4) screws that secure the removable media bracket to

2. Insert the removable media drive mechanisms into the removable

Chapter 1

the cabinet chassis, and pull the bracket out of the cabinet.

media bracket,

and secure the drives to the bracket with eight (8) screws (two on

each side for each drive).

D Class Internal Peripherals Installation

Installation Procedures

1- 11

Table of Contents