Setting The Contact, Location, And Serial Number Of The Snmp Agent - Cisco NCS 6000 Series Configuration Manual

Setting the Contact, Location, and Serial Number of the SNMP Agent

Command or Action
Step 4
snmp-server host address [traps] [version {1 | 2c | 3
[auth | noauth | priv]}] community-string [udp-port
port] [notification-type]
Example:
RP/0/RP0/CPU0:router(config)# snmp-server host
12.26.25.61 traps version 3
noauth userV3noauth
Step 5
snmp-server traps [notification-type]
Example:
RP/0/RP0/CPU0:router(config)# snmp-server traps
bgp
Step 6 commit
Step 7 show snmp host
Example:
RP/0/RP0/CPU0:router# show snmp host
Setting the Contact, Location, and Serial Number of the SNMP Agent
This task explains how to set the system contact string, system location string, and system serial number of
the SNMP agent.
The sequence in which you issue the snmp-server commands for this task does not matter.
Note
SUMMARY STEPS
1. configure
2. (Optional)
3. (Optional)
4. (Optional)
5. commit
System Management Configuration Guide for the Cisco NCS 6000 Series Router, Release 5.0.x
72
snmp-server contact system-contact-string
snmp-server location system-location
snmp-server chassis-id serial-number
Purpose
Specifies SNMP trap notifications, the version of SNMP to
use, the security level of the notifications, and the recipient
(host) of the notifications.
Enables the sending of trap notifications and specifies the type
of trap notifications to be sent.
• If a trap is not specified with the notification-type
argument, all supported trap notifications are enabled on
the router. To display which trap notifications are
available on your router, enter the snmp-server traps ?
command.
(Optional)
Displays information about the configured SNMP notification
recipient (host), port number, and security model.
Implementing SNMP